After SCCM Primary site is installed successfully, the next thing is to
distribute the boot image to Distribution Point, There are 2 boot image
packages which are created by default for different system architecture.
They are under - Software Library\Operating Systems\Boot images
Right click in the boot image & select "Properties" They are few settings which needs to be changed before the boot image are distributed to the DP:-
Go to the Data Access Tab & check "Copy the content in the package to a package share on the distribution point" (This will copy the boot image bits to the distribution point) :-
Go to the "Distribution Settings" Tab & set the :-
Priority to High,
Check "Distribute the content of the package to the preferred distribution points"
Select - "Automatically download content when packages are assigned to the Distribution Point"
Go to the Customization Tab & check "Enable command support (testing only) & the click on OK"
Right click on the Boot image & select Distribute Content :-
Click on Next :-
Click on Add :-
Select Distribution Point :-
Check the Distribution Point & click on OK :-
Click on Next to continue :-
Click Next :-
Click on Close to end the Wizard :-
Once the package is distributed successfully the Content Status for the package will change to Green (When the Content distribution is in progress the content status us Yellow) :-
You can go to the Distribution point folder & verify if the package was distributed to the DP, a folder with the package id is created in DP, for the boot image we distributed the package id was DMW00005 & it has been copied successfully to the DP :-
No comments:
Post a Comment